CyberOptics Corp. announced that it has been awarded a 2018 NPI Award in the category of Test and Inspection – SPI for its SE3000 Solder Paste Inspection (SPI) system. The award was presented to the company during a Tuesday, Feb. 27, 2018 ceremony that took place at the San Diego Convention Center during the IPC APEX EXPO.

Dr. Subodh Kulkarni, President & CEO, CyberOptics Corporation Receiving NPI Award at APEX for the MRS-Enabled SE3000 3D SPI (Photo: Business Wire)

The new SE3000 SPI system incorporates Multi-Reflection Suppression (MRS) sensor technology with a finer resolution for accuracy, repeatability and reproducibility – even on the smallest paste deposits and 0201 metric components.

SE3000 fully supports feedback and feed forward capability with leading Solder Paste Printer and SMT Mounter vendors respectively. SE3000-DD Dual lane, Dual sensor and SE3000-X for large board capability also are available. With simple configuration settings, SE3000 gives you the power to do more with SPI results – optimize printing process, establish stencil cleaning cycles and fine-tune printer setup. All of this means reduced rework costs, increased production throughput and improved yields.

About CyberOptics

CyberOptics Corp. is a developer and manufacturer of high precision sensing technology solutions. CyberOptics sensors are being used in general purpose metrology and 3D scanning, surface mount technology (SMT) and semiconductor markets to significantly improve yields and productivity. By leveraging its leading edge technologies, the company has strategically established itself as a global leader in high precision 3D sensors, allowing CyberOptics to further increase its penetration of its key vertical markets. Headquartered in Minneapolis, Minnesota, CyberOptics conducts worldwide operations through its facilities in North America, Asia and Europe.

For more information, visit www.cyberoptics.com.