CAMI Research has released a 64-pin Header Isolator for its CableEye automation-ready, cable and wire harness test systems. Recommended when there is a need for repeat connection and disconnection of test fixture cables, it is designed to allow users to minimize bent pins and wear of the headers on the main unit, expansion modules, and free-standing QuickMount housings. The device may be used with any CableEye model and is rated to 500 Vdc/ac.
CAMI offers the CableEye suite of products complete with accessories – including plug-in connector boards. The selection of these test fixture boards is growing and is currently numbering over 60 – most of which are populated with families of connectors. When pre-populated boards are used, the tester GUI automatically displays a graphic of the connectors under test. The tester can be programmed to do the same for custom boards and fixtures.
For wire/cable test interface connections only, this device attaches to any tester header in the same way as CAMI connector boards. The CB25A solution (Item 755A, rated to 500 Vdc/ac), which attaches to headers only on the main unit or QuickMount housings, can be used with either wires/cables or CAMI connector boards. For higher test voltages (up to 1500 Vdc/1000 Vac) we offer Item 778A for base unit (i.e. top deck) and QuickMount headers and Item 778B for expansion module headers.
